OK i saw this code below from this post...
Run Query to Reset Count to *
Forum thread count to X amount for selected forum identification number
# replace vbb_ with your vB table prefix Example: [vbb_forum] if non leave blank
# replace X with new total
# replace X with the forum id(s)
Code:
UPDATE forum SET threadcount = 'X' WHERE forumid = 'X'
I dont know where or if I input this code into the code above
Also will this work with vb 3.8?
Thanks!
Code:
http://www.vbulletin.com/forum/showthread.php?t=228617
Forum thread count to X amount for selected forum identification number
# replace vbb_ with your vB table prefix Example: [vbb_forum] if non leave blank
# replace X with new total
# replace X with the forum id(s)
Code:
UPDATE forum SET threadcount = 'X' WHERE forumid = 'X'
I dont know where or if I input this code into the code above
Code:
# replace vbb_ with your vB table prefix Example: [vbb_forum] if non leave blank
Thanks!
Comment